Instructions:

Immerse the customized prosthesis in a cup of hot water (155°F-180°F, 68°C-82°C). Wait until the specially formulated thermoplastic resin inside the gum tray of the prosthesis set becomes translucent.

Remove the prosthesis with a spoon and ensure that the prosthesis is not too hot to handle. While the prosthesis is still warm, centre the teeth in the prosthesis set and push upwards until the teeth reach the bottom of the gum tray.

Wait a few seconds, but before the thermoplastic material hardens, gently remove the prosthesis downwards.

Trim the excess thermoplastic material with scissors and let the prosthesis cool and harden for about 5 minutes.

For a quick set, immerse the prosthesis in cold water.

If the prosthesis imprint does not fit your teeth, immerse the customized prosthesis in a cup of hot water (155°F-180°F, 68°C-82°C) and repeat the above procedures.

There is no mixing or curing, hence no smell and no chemical risk. CAN BE REUSED AGAIN AND AGAIN!

Warnings:

Not suitable for children under 14 years.

Do not use on orthodontic appliances, plates, crowns, or any dental work.