Diamond FX

Diamond FX Facepaint is a high-quality water-based colour that can be applied directly to the skin. To activate it, simply use a small amount of water. The amount of water used affects the final result, so it is advisable to use a minimal amount for the best effect.

To apply the colour, you can use sponges and/or brushes:

- Sponges: You can cut a sponge in half and use two colours on each half. Using the more prominent side of the sponge, you can blend the colours together. Lightly dampen the tip of the sponge and squeeze out the excess water, then rub it on the colour until it absorbs some. Apply the colour to the face by rotating the sponge on the skin. Remember never to leave the sponge on top of the colour pot.

- Brushes: Wet the brush and remove excess water by dabbing it on a paper towel. Pick up the colour with the bristles of the brush and apply it to the skin. Make sure never to leave the brush in the colour pot or in the water.

Safety and hygiene are paramount when using the product. Ensure you work in hygienic conditions, using a clean sponge and/or brush for each person. To ensure the cleanliness and hygiene of the material, use appropriate cleaning products. Before closing the colour pot, ensure it is dry inside and there are no traces of water, as this could cause the formation of bacteria.

If skin irritation occurs during use, stop using the product immediately. Avoid leaving the colour around the eyes and mouth for too long, as these are sensitive areas of the skin. To avoid damaging the products, do not mix Diamond FX Facepaint with other brands.

Finally, remember to follow safety protocols for COVID-19 prevention when using the product.